Canoe Boat Plans | Window installation

Canoe Boat Plans

The windows for the boat came  from Motion Windows, and after over year in the barn they are finally installed. Theres a link to Motion on this page to the right.

All the windows in the salon are of the same size; tinted, and sliders. The wheel house has two fixed windows, and two top hinged windows on the forward wall. Also in the wheel house, there are two sliders and a fixed to starboard, and one slider, the passage door, and a fixed window to port. The windows on the front of the wheel house are un-tinted, 1/2" tempered. The only tinted windows in the wheel house are the two small fixed  units aft.

All the windows are held in place using a clamp ring. The window has a flange on it that gets a bead of sealant applied, and lands on the outside of the boat. The clamp ring flanges against the interior trim, and is held in place with 15 or so screws that thread in to a groove in the window. The screws pull everything tight, and the sealant makes a water tight seal. The boat side of the window flange has six or 8 dados extruded in to it, so that a gasket is made by the sealant, which prevents metal on metal contact along with a water tight seal. The trim ring method is the best way in  my opinion to install windows like this as no drilling or damage to the hull sheathing happens. It is also an extremely fast install, and minor alignment is possible. The fast installation was due to me spending three days while the super structure was in the barn fitting the interior trim piece for each window and making sure all the openings were dead nut. I"m pretty sure I blogged about the interior trim fit up so if anyone cares, theres more detail in that blog post. Sika-Flex UV resistant marine sealant was used and recommended by the window manufacturer.

After the first window went in, we had to make a decision on how to deal with the squeeze out of the black sealant. I started to tool the joint, and attempt to wipe things clean, but I soon found things getting out of hand. The sealant was on my hands, and clothes along with getting on the powder coated window, and finding its way to the boat quite a distance away from the window. The stuff seemed to jump! So after getting that mess cleaned up, we decided it was going to be best to deal with the squeeze out once the material cured. I messed around with it a bit the other day and to my pleasant surprise, it does pull away from the paint ( with some effort ) at the paint/ window flange joint. A hard plastic tool or plastic scraper will be needed to coax the material off of the boat.

Im very happy with the quality of the windows, and how secure the installation feels. With the type of sealant we used and how much squeeze out were seeing, Im extremely confident we have a water tight seal. Some of the smaller windows with tight bends we found the groove that the trim ring screws in to had distorted a little bit. The manufacturer included a bag of the next size larger screw with my package which worked out most excellent in the larger groove, thus keeping everything nice and tight. This is the second boat Ive used Motion Windows on and I am for sure a happy customer.

Now that the window  install is complete,the next order of business is to finish painting the salon wall weld joint on the aft deck, then scuff, and paint the weld joint on the inside. The salon door and wheel house door will then

be installed.  Once this is complete, Ill bolt on some wood to the few frames that need it, then get the foam finished. Some fairing and priming on the outside weld along with the intake and exhaust louvers on the stack, and well be weather tight.

Cheers 

Do you find information about Canoe Boat Plans are you looking for? If not, below may help you find more information about the Canoe Boat Plans. Thank you for visiting, have a great day.